Schmitt32 Mini Line Drill (Classic)


The Schmitt32 mini line drilling system features a quality plywood construction with an aluminum notched guide rail and side pin rails.  The mini system is factory calibrated and ships as a fully assembled unit.  The schmitt32 MINIs include the panel locating fixture, the notched guide rail with row numbers, the router base attachment with ratchet pawls, a 5mm brad point carbide tipped bit with adapter bushing, mounting bolts, set up and operating instructions.

The Schmitt32 can accurately  drill clean and precise holes located in a square 32mm grid pattern starting at 37mm (industry standard) from the front edge of a panel and 32mm or 64mm down from the top edge covering a maximum panel size of about 30 x 40 inches.  This entire grid pattern or any one hole or row of holes can be moved anywhere over the surface of the panel by use of shop made spacer blocks placed between front fence and or the end stops.  Usually most of the possible hole locations are not needed.   You drill only those holes needed for hinge placement, drawer hardware placement and alignment, and adjustable shelves.

3 in stock


The plunge router is not included.

The router base allows a small front to back adjustment of the columns of holes so that the placement of hinge plates and drawer slides can be moved slightly closer or farther from the cabinet front edge if desired.  The top row of holes is typically calibrated by a one time adjustment of the end stops to 64mm from cabinet top edge to #2 hole center.  These adjustments usually need to be made only once when doing the initial set up of the system.


There are no reviews yet.

Be the first to review “Schmitt32 Mini Line Drill (Classic)”

Your email address will not be published. Required fields are marked *

Free Shipping within the Contiguous United States Dismiss